“Traveling with the prince had its perks: normally Enoch always slept on the cheapest straw bed when staying at an inn, but the prince had rented out a whole floor, including nice beds with feather mattresses.”
The Clorehaven Manor Inn is an absolutely massive modular building for tabletop role-playing and wargaming.
The full set includes all the pieces needed to make four above-ground floors, a basement, plus modular roofing. Each floor has multiple rooms to be used in any way as you see fit. Once constructed, the Inn measures approximately 21"x14.5"x14".
The walls, floors, and roof pieces are all modular pieces that are connected using OpenLock clips (included), so they can be modified to suit your needs or repurposed to make your own buildings. Note that because the basement would go below the first floor, so some scenery modeling will be needed to make the first floor doors level with the ground you are playing on if you wish all the floors stacked on each other simultaneously.
The item comes unpainted in almost 700 pieces (plus all the necessary OpenLock clips). As with all 3D prints, some finishing may be required.
All items are printed in non-toxic PLA filament. Item is printed at a high 0.15mm resolution (and an ultra high 0.1mm resolution for small pieces).
Pictured item is at 28mm scale. Custom print resolutions are available and can be used if requested.
This item is part of Printable Scenery's Clorehaven & the Goblin Grotto Kickstarter, which can be found via this link. Items are commercially licensed from Printable Scenery.
Any of the items from Printable Scenery can be printed. Feel free to request anything that you see.
This item takes 3–4 weeks to ship.